SCP Series Solar Pool PumpsAssembly and Installation Manual4009458Conforms to UL Stds 1081 & 1563 325 E. Main Street Safford, AZ 85546Phone (92
1. Turn off motor.2. Relieve pressure in the system.3. Turn the lid in a counter-clockwise direction until it stops. 4. Lift lid and remove basket. 5.
1. Remove pump base from shipping box and place on a flat surface. 3. Place the stainless steel flat washers over the base flanges on each si
6. Rotate the pump shaft adapter until the set screws are aligned to the center of the motor adapter slot. This will be about a 45 degree ang
11. Now the impeller and the pre-load on the shaft seal needs to be adjusted. With a large flat point screw driver, pry the motor shaft
SCP SERIES POOL PUMP Installation & Operating Instructions GENERAL Your pump has been engineered to give maximum efficiency under normal pool
NOTE: If pump is installed below water level of pool, close return and suction lines prior to opening hair and lint pot. Make sure to re-open valves
TROUBLE SHOOTING If pump looses prime, or if too many bubbles come through return line, check: 1.) Hair and lint pot cover is tight and O-ring is in
SCP Series PoolPumps Safety WarningsIMPORTANT SAFETY INSTRUCTIONSREAD AND FOLLOW & SAVE ALL INSTRUCTIONSWARNING: Before installing this product, r
WARNING: This pool pump must be installed by a licensed, certified electrician or qualified pool serviceman inaccordance with the National Electric Co
Kommentare zu diesen Handbüchern